Amateur Radio Station K9DUR
Continuously Licensed Since 1960
Amateur Radio Software 

SmartSDR® Utilities

The following programs were written by Ray Andrews, K9DUR, for use with SmartSDR® by FlexRadio Systems. They may be freely distributed for non-commercial purposes as long as no fee is charged except for the cost of the distribution media.

Attention SmartSDR® v3 Users

As of May 12, 2019, all of my programs designed to work with SmartSDR® have been superficially tested with SmartSDR v3 and all appear to work properly in a single-client environment.

However, until I have been able to perform more thourough testing, most are NOT officially supported using SmartSDR v3.  Exceptions are noted in the individual program listings.

At this time, none of the programs are guaranteed to work properly in a multi-client environment, and are therefore not supported for multiFLEX® operation.

I do not charge for any of the programs available on this page.  However, developing & maintaining them is time-consuming.  A donation to show your support is always welcome.

Please click on the Donate button below to go to my donation page where you can make a secure donation using PayPal. Thank you.

Although the programs are free, they are not open source.  All programs are the intellectual property of and are copyrighted by RNA Consulting Services, LLC,  They may not be decompiled or reverse engineered for any purpose.






t MorseKeyer6k (v2.0.1 - Released: 02/07/2019) -- This program provides an enhanced CW keyboard/memory keyer system for SmartSDR.  (Requires SmartSDR v1.4.11 or later.)

Download the User's Guide for more information about the program.

t SDRAutoCenter (v2.2.1 - Released:  05/03/2019) -- This program automatically adjusts the panadapter center frequency as you tune around the band.

Download the User's Guide for more information about the program.

t SDRMemory6k (v5.0.1 - Released: 05/03/2019) -- This program provides an enhanced memory management system for SmartSDR.

Download the User's Guide for more information about the program.

t SDRMonitor (v2.3.1 - Released: 05/13/2018) -- This program displays 2 small windows containing the power supply voltage and power amplifier temperature of a FLEX-6000 series transceiver.

Download the User's Guide for more information about the program.

NOTE:   This version requires SmartSDR v1.10 or later.

SDRMonitor works properly with SmartSDR v3 and is supported in a single-client environment.
multiFLEX® operation is not supported.

t SWRPlotter6k (v3.2.1 - Released: 01/25/2019) -- This program allows you to plot SWR charts of your antenna system using a FLEX-6000 series transceiver.

Download the User's Guide for more information about the program.

t VoiceKeyer (v5.4.0 --  Released: 10/11/2018) -- A digital voice keyer which allows selection of the sound card used to interface to the radio

VoiceKeyer works properly with SmartSDR v3 and is supported in either a single-client or
multi-client environment.  multiFLEX® operation is supported.


What do I do if a program cannot "see" my radio?
Most of these programs communicate directly with the radio over your local area network (LAN) using an ethernet or WiFi connection.  In order for this to work, often the program must be manually granted permission to go through the Windows Firewall. The following document will give you step-by-step instructions on how to grant this permission:

Last Update:
May 12, 2019
Copyright© 2019 -- RNA Consulting Services, LLC.

QTH.com Web Hosting